dc.description.abstract |
“Petti and Para” a crude form of Axial flow pump is used in Kerala for dewatering agricultural fields. It is being fabricated by local blacksmiths and there is no scientific design for the pump. For low head high discharge conditions Petti and Para is very effective, but less efficient because of faulty construction.
The broad objective of the project was to develop an axial flow pump with improved efficiency which could be economically used for dewatering and for lift irrigation purposes under low head conditions.
In this investigation, a good amount of attention was given to the fluid dynamics inside the axial flow pump and theoretically studied the combined affect of various parameters involved in the design of an axial flow pump. Then the parameters were compared with the approximate values given by the various researchers in the field. The requirement of the pump to be designed, at field conditions, were studied thoroughly and an one dimensional design was done.
After designing and fixing the dimensions, the pump was fabricated in the Kerala Agricultural University Research Workshop at Mannuthy. Because of the lack of facilities in the Research Workshop, it was tested in the hydraulics laboratory at the Government Engineering College, Trichur. The power unit used was a 15 HP electric motor. The accessories used to measure discharge and head were a rectangular notch with Hookgauge and water manometer respectively. Testing was done with two levels of water above the impeller, one 20 cm above the impeller and the other 10 cm above the impeller. For the above two conditions, at designed head (1.5m) the maximum efficiencies obtained were 33 per cent and 29.5 per cent at discharge 121 lit/sec. and 114 lit/sec. respectively. The maximum working capacity was 165.19 lit/sec. against a head of 1 m with an efficiency of 31.95 per cent (20 cm above the impeller)
In the three bladed pump, the blades were fixed to the hub by welding it to the suitably shaped (curved) M.S flats and then bolting the curved M.S. flats to the hub. The blades were twisted from 160 to 240 in a uniform variation by simple blacksmithy. The efficiency of the pump can be increased by using perfectly curved blades, which reduces eddies and skin friction. Comparing with the existing Petti and Para made by local blacksmiths, it is found that the pump is cheap as well as efficient. |
en_US |